It is a fact that the average longevity of ATV handlebar grips is quite short and they might not even last for one year. In that case, you need to replace them although the task is not that simple. In the subsequent paragraphs, we have mentioned some simple tips to install the grips on your ATV that will come of use to you. These guidelines will help to make sure that the grips do not slide off or spin.

1. Brake cleaner

You can make use of brake cleaners for providing lubrication to the grips before sliding them on. Simply slide the new grip into the proper position by using the brake cleaner for spraying the internal parts of the handlebar and the grips. The good thing is that the cleaner is going to evaporate within a short time so you are good to go.

2. Carb cleaner

If you are using a rubber slide on the grip, you will find it tough to slide the fresh grips on since they tend to get folded due to the presence of the thin rubber while you are pushing them on. On the other hand, there will be enough lubrication for sliding the grip on with the help of a carb cleaner, and just like the brake cleaner, this one will likewise evaporate away in no time at all. Therefore, make sure to slide the handlebar grip on almost instantly while the card cleaner is still there.

3. Dish soap and water

This method will be ideal for you if you would like to provide some time for the new grips to be set in place. In the two methods mentioned above, you will need to slide the ATV handlebar grips on before the evaporation of the lubricants take place. In this case, pour a mixture of equal amounts of water and dish soap into the new handlebar grip and spread it around such that it covers the entire rubber. Following this, line up the new grip in any manner you like after sliding it onto the handlebar. Allow the stuff to remain like that for 24 hours for the water and soap to become dry.

4. Aerosol hairspray

If you have already used hairspray in the past, then it must be known to you that it remains wet once you spray it, and then it becomes sticky after a few seconds. You can make use of hairspray for installing the handlebar grips as well. It will provide you with some more time while installing the grips, following which the solution will hold the grip in position. Make sure to use Aerosol Hairspray since apart from providing you with a steadier spray, it will offer you more time for installing the grip. It will be a sensible idea to allow the hairspray to become dry within the grip before riding heavy, and for this, you need to wait for approximately 60 minutes.

Just like other electric scooter accessories, you will also find these handlebar grips at any store in your locality as well as online. It is recommended for you use top-quality grips for your ATV. It will provide you with a pleasant riding experience in the long run.