Fuel tanks are essential parts of vehicles. They store gasoline or diesel fuel and provide energy to power engines. The fuel tank also helps prevent leaks from occurring. If the fuel tank leaks, then the vehicle won’t start. If your vehicle isn’t starting and you don’t feel like breaking the bank with repair costs, remember that you can sell any car in Dubai – no matter its condition!

Fuel tank pressure sensors (FTP) monitor the fuel level in vehicles. They are also known as fuel gauge sensors or fuel gauges. FTPs are usually at the bottom of the fuel tank. The sensor sends signals to the dashboard indicating whether the fuel tank has enough fuel.

What Does the Fuel Tank Pressure Sensor Do?

A fuel tank pressure sensor measures the pressure inside the fuel tank. It sends a signal to the computer telling it whether the fuel level is too high or too low. The computer uses that data to adjust the amount of fuel injected into the engine.

The fuel pump delivers fuel from the tank through the filter and injector. If there isn’t enough fuel in the tank, the pump won’t be able to push all the fuel out of the tank. That will cause the pressure in the tank to drop. When this happens, the computer will increase the amount of the pumped fuel.

How to Check a Fuel Tank Pressure Sensor?

Checking fuel tank pressure sensors is a simple task that requires only a couple of tools. Here’s a step-by-step guide to doing so:

Remove the Fuel Filter

Before starting, make sure that the vehicle is running and that the engine is warm. Next, remove the fuel filter cap and pull out the fuel line connector.

Disconnect the Fuel Line Connector

Locate the Fuel Pump

Locating the fuel pump is fairly straightforward. There are usually four wires coming out of the fuel pump. One wire goes to the battery negative terminal, another goes to the ignition switch, and the remaining two go to the fuel pump itself.

Test the Fuel Pump

Test the fuel pump by connecting the black wire to the red wire and the white wire to the ground. If all four wires are attached to the correct terminals, the fuel pump should turn on.

Replace the Fuel Filter Cap

Replace the fuel filter cap and reconnect the fuel line connector. Now, test the fuel pump again. If everything worked correctly, the fuel pump should now be operating properly.

Signs of a Malfunctioning Fuel Tank Pressure Sensor

If any of these signs appear, your fuel tank pressure sensor may have malfunctioned. You can check for malfunctions using a multimeter. A multimeter is an electronic device used to measure voltage, current, resistance, capacitance, frequency, and other electrical properties.

Warning Light

If you see the engine warning light come on on your dashboard, it could be a sign that your fuel pressure sensor is bad.

Sometimes the engine control unit detects a problem with the fuel rail sensor signal. Then it will activate the check engine light to let you know that there is some kind of problem with the engine.

Weak Power

If you step on the accelerator pedal and notice a decrease in your acceleration power, it may be due to the fuel pressure sensor.

A bad sensor interferes with the air and fuel ratio. That will cause your car to lose power while you are driving.

Starting Problem

If you’re trying to start your vehicle’s engine and it regularly gives you trouble, your fuel pressure sensor is probably not sending a good signal to the engine computer.

Engine Stalling

Sometimes you might get startled and cause your vehicle to stall while you are driving it. If you’ve ever had trouble starting your car but then got the engine started, you may stall while driving later.

If you don’t feel satisfied with your faulty car, you can always cash your car in UAE and buy a new one instead!

Poor Energy Efficiency

When the engine does not receive the correct amount of fuel for its internal combustion process, it does not release the right amount of energy for other car components to work properly.